â– Set operating parameters.
â– Gain access to Global Configuration mode.
Password Protection
If the system administrator has configured the system to have a password, the CLI
prompts you to enter that password before you receive access to Privileged Exec
mode. The password is case sensitive and appears as asterisks on the screen.
To access Privileged Exec mode:
1. At the prompt, type enable and press Enter.
host1>enable
Password:
2. At the password prompt, type your password and press Enter.
Password:*********
host1#
NOTE: The > character in the command-line prompt changes to the # character.
host1# ?
baseline Set a baseline for statistics
clear Clear a state
clock Set the system's clock
configure Enter Global Configuration mode
copy Copy files
debug Configure debugging functions
default Set a command to its default(s)
delete Delete a local file
dir Display a list of local files
disable Reduce the command privilege level
disconnect Disconnect remote CLI session
enable Enable access to privileged commands
exit Exit from the current command mode
flash-disk Perform flash disk operations
halt Halt the system in preparation for power down
help Describe the interactive help system
ip Configure IP attributes on an interface
ipv6 Configure IPv6 attributes
l2tp L2TP operations
log Configure logging settings
logout Logout PPP Subscribers
macro Run a CLI macro
more Display contents of a file
mpls Execute MPLS commands
mtrace Trace the path that packets will traverse from source
to
destination for a given group
no Negate a command or set its default(s)
ping Send echo request to remote host
pppoe Set PPPoE information
profile-reassign Perform profile reassignment
Accessing Command Modes â– 87
Chapter 2: Command-Line Interface
To Next Page
Loading...
Need help?
General
