Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X User Manual

■ The CLI prompts you for message text if you do not begin or complete the
message on the same line as the send command. The CLI reminds you to signal
the end of the message either with the delimiter or Ctrl+z.
■ Example
host1#send 0 “ hello console”
■ There is no no version.
■ See send.
Managing Memory
The system performs most memory management tasks automatically. The system
allocates some memory permanently and some memory temporarily. When
applications are deleted, memory that the system assigned temporarily becomes
available again.
The system releases available memory on an SRP module or line module automatically
if that module requires extra memory for an application. However, you can force
the system to release available memory on the primary SRP module if you issue
either the show processes memory command or the show utilization command.
For information about the show processes memory command, see “Managing Files”
on page 290. For information about the show utilization command, see “Managing
Modules” on page 355.
NOTE: When you issue the show utilization command, the system releases available
memory on the SRP module immediately; however, the display appears a few seconds
later.
Managing Files
You are responsible for file management. Table 33 on page 290 shows the types of
system files and their corresponding extensions.
Table 33: Types of System Files and Corresponding Extensions
DescriptionExtensionType of File
Snapshot of the system’s configuration*.cnfConfiguration
File you can create for troubleshooting if a module fails*.dmpCore dump
Details of when and why modules rebooted*.hty
(reboot.hty)
History
A series of messages that describe events that occurred on
the system
*.logLog
290 ■ Managing Memory
JUNOSe 11.1.x System Basics Configuration Guide

Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X Specifications

General

Brand	Juniper
Model	SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X
Category	Software
Language	English