multicast-routing Enable IP multicast forwarding
name-server Configure DNS server
pim Configure PIM Protocol
prefix-list Configure a prefix list entry
prefix-tree Configure a prefix tree entry
route Define a static IP route
router-id Configure the router-id to be used
rpf-route Define a static IP route for mcast RPF check
source-route Configure source-routing capabilities
ssh Configure SSH characteristics
ttl Configure the default value to be used by IP for
Time-To-Live
tunnel Configure tunnel parameter
vpn-id Configure the VPN ID associated with this router
vrf Specify a VRF
host1(config)#ip
Example 3 host1(config)#ip community-list ?
<1 - 99> The community list
host1(config)#ip community-list
When you want to see a list of commands that begin with a particular set of
characters, type a question mark ( ? ) immediately after the last letter. Do not use a
space between the partial keyword and the ? key. For example:
host1#sh?
show shutdown
host1#sh
NOTE: If you want to use the ? character as part of a string, such as a hostname or
a regular expression, you must enter the following key sequence: Ctrl+v+?.
Otherwise, the CLI considers the ? to be a request for assistance in completing the
command.
help Command
Use the help command when you want to see a brief description of the
context-sensitive help system.
host1>help
Use the help options as follows:
?, or command<Space>? - Lists the set of all valid next keywords or arguments
partial-keyword? - Lists the keywords that begin with a certain character
string
partial-keyword<Tab> - Completes the partial keyword
host1>
Partial-keyword <Tab>
When you cannot recall a complete command name or keyword, type in the first
few letters, press Tab, and the system completes your partial entry. You must type
enough characters to provide a unique abbreviation. If you type a few letters, press
66 ■ Using Help
JUNOSe 11.1.x System Basics Configuration Guide
To Next Page
Loading...