Configuring Collectors and Receivers
To configure the router to collect statistics:
1. Add names to the FTP host table for the primary and secondary (optional)
receivers.
See “Copying and Redirecting Files” on page 301 in “Managing the System” on
page 251, for information about adding names to the host table.
2. Specify the type of interface on which you want to collect statistics.
host1(config)#bulkstats interface-type ppp collector 2
3. Specify the parameters for the receivers.
host1(config)#bulkstats receiver 1 remote-name js:/ftptest/bulk%s%s.sts
sysName sysUpTime
4. Assign the data collector.
host1(config)#bulkstats collector 2
5. Specify the method for data collection.
host1(config)#bulkstats collector 2 collect-mode auto
6. Assign the primary receiver.
host1(config)#bulkstats collector 2 primary-receiver 1
7. (Optional) Assign the secondary receiver.
host1(config)#bulkstats collector 2 secondary-receiver 5
8. (Optional) Specify the time for which the system transfers data.
host1(config)#bulkstats collector 2 interval 1000
9. (Optional) Set the maximum size of the bulk statistics file.
host1(config)#bulkstats collector 2 max-size 20480
10. (Optional) Add descriptive information to the bulk statistics file.
host1(config)#bulkstats collector 2 description customer xyz
11. (Optional) Set the encoding scheme of the ifDescr and ifName objects.
host1(config)#bulkstats interfaces description-format common
12. (Optional) Set the system to retrieve bulk statistics once only.
host1(config)#bulkstats collector 2 single-interval
13. (Optional) Configure bulk statistics traps.
Collecting Bulk Statistics ■ 199
Chapter 4: Configuring SNMP
To Next Page
Loading...
Need help?
General
