NOTE: The filename must end with an .scr extension, and the file must contain a
series of valid CLI commands. The file can be a local file on the router or a remote
file on a host system.
2. Press y or Enter to confirm; pressing any other key aborts the procedure.
host1#
For more information, see the section “Managing Files” on page 290 in “Managing
the System” on page 251.
AAA Profile Configuration Mode
From this mode, you can restrict or allow the use of domain names, translate an
original domain name to a new domain name, or create domain name aliases.
From Global Configuration mode, type the aaa profile command and a profileName,
and then press Enter.
host1(config)#aaa profile charlie
host1(config-aaa-profile)#?
allow Configure the authorization domain name
default Set a command to its default(s)
deny Configure the authorization domain name
do Run an exec mode command (alias command run)
exit Exit from the current command mode
help Describe the interactive help system
log Configure logging settings
macro Run a CLI macro
no Negate a command or set its default(s)
run Run an exec mode command (alias command do)
sleep Make the Command Interface pause for a specified duration
translate Configure the translation map for domain name
Address Family Configuration Mode
From this mode, you can configure address family parameters for BGP VPN services
or RIP VPN services.
From Global Configuration mode, type the router bgp command to enter Router
Configuration mode for BGP. Type either the address-family ipv4 or address-family
vpnv4 command, and then press Enter.
host1(config)#router bgp 100
host1(config-router)#address-family ?
ipv4 Configure IPv4 address family
vpnv4 Configure VPN-IPv4 address family
From Global Configuration mode, type the router rip command to enter Router
Configuration mode for RIP. Type the address-family ipv4 command, and then press
Enter.
Accessing Command Modes ■ 89
Chapter 2: Command-Line Interface
To Next Page
Loading...