Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X

help Describe the interactive help system
log Configure logging settings
macro Run a CLI macro
next-parent Specify the next parent group to call in hierarchy
no Negate a command or set its default(s)
rate-limit-profile Specify a hierarchical rate limit profile
run Run an exec mode command (alias command do)
sleep Make the Command Interface pause for a specified
Policy List Configuration Mode
In this mode, you can configure a policy list—that is, a set of rules—that you can
attach to an interface. You can modify a policy list and update it wherever the policy
list is used in the configuration.
To create a policy list, from Global Configuration mode type policy-list command
preceded by the type of policy and press Enter. For example,
host1(config)#l2tp policy-list routeL2tp100
NOTE: If you do not include the type of policy, the system creates an IP policy list.
host1(config)#ip policy-list routeForABBCCorp
host1(config-policy-list)#?
classifier-group Specify the classifier list
color Create a color policy
default Set a command to its default(s)
do Run an exec mode command
exit Exit from the current command mode
filter Create a filter policy
forward Create a forward policy
help Describe the interactive help system
log Configure logging settings
macro Run a CLI macro
mark Create a set TOS byte policy
next-hop Create a next-hop policy
next-interface Create a next-interface policy
no Negate a command or set its default(s)
rate-limit-profile Create a rate-limit policy
run Run an exec mode command (alias command do)
sleep Make the Command Interface pause for a specified
duration
suspend Suspend a policy rule
traffic-class Create a traffic class policy
traffic-shape-profile Create a traffic-shape policy
user-packet-class Create a user packet class policy
Policy List Parent Group Configuration Mode
In this mode, you can configure a parent group in a hierarchy.
From Policy List Configuration Mode, type the parent-group command and specify
a parentGroupName, and press Enter.
108 ■ Accessing Command Modes
JUNOSe 11.1.x System Basics Configuration Guide