Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X User Manual

■ Use the no version to delete the specified schema.
■ See bulkstats schema subtree policy.
bulkstats schema subtree qos
■ Use to configure the bulk statistics schema to collect QoS statistics and
configuration information on egress queues belonging to different interface types.
■ To export egress queue statistics based on the queue attributes specified for the
QoS schema, use the subtreelist keyword.
■ To export the summarized QoS rate statistics over each S-VLAN or ATM virtual
path, use the export-summarized-stats keyword.
■ Specifying the export-summarized-stats keyword enables the export of the
summarized statistics over each S-VLAN or ATM virtual path. To ensure that you
successfully receive the summarized statistics, do not filter out the forward-rate
and aggregate-dropped-rate attributes from the egress queue data. To accomplish
this, use either the bulkstats schema subtree qos all command or the bulkstats
schema subtree qos forwarded-rate aggregate-dropped-rate command.
■ Example 1—Configures the QoS schema to export all egress queue attributes
host1(config)#bulkstats schema 4 subtree qos subtreelist all
■ Example 2—Configures the QoS schema to export summarized QoS rate statistics
host1(config)#bulkstats schema 4 subtree qos export-summarized-stats
■ Use the no version to remove the QoS schema.
■ See bulkstats schema subtree qos
bulkstats schema subtree system
■ Use to retrieve global system and per-module statistics and information.
■ The schema retrieves global statistics sysUpTime and nvsUtilPct.
■ The schema retrieves per-slot statistics and information such as the slotDescr,
the cpuUtilPct, and the memUtilPct.
■ Example—Configures the schema to collect the system statistics.
host1(config)#bulkstats schema 4 subtree system
■ Use the no version to delete the specified schema.
■ See bulkstats schema subtree.
Mapping Bulkstats Output to MIB Flies and CLI Configurations for Bulk Statistics Schema
Bulk statistics organizes data in the form of schema definitions. You can configure
the schemas to retrieve specific accounting information by using the CLI or the SNMP
MIB objects. The schemas support attributes that point to specific MIB objects. To
retrieve specific network accounting information you must configure the CLI to query
the corresponding MIB object.
Collecting Bulk Statistics ■ 223
Chapter 4: Configuring SNMP

Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X Specifications

General

Brand	Juniper
Model	SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X
Category	Software
Language	English