Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X User Manual

mode, and opens the data channel to the server. This method of establishing the
FTP connection allows both the control channel and the data channel to pass through
the firewall in the allowed direction.
Configuring Authentication
Before you enable the FTP server, configure the authentication procedure for the vty
lines, as follows:
1. Configure host access lists.
2. Configure user authentication methods.
3. Configure the vty lines to use the host access lists and user authentication
methods.
You can specify authentication by a RADIUS server or by password checking. If you
choose no authentication service, any client can access the FTP server. For information
about authentication on vty lines, see “Managing the System” on page 251.
Configuration Tasks
FTP is disabled by default. You must enable the FTP server with the ftp-server
enable command before the system allows FTP clients to connect.
ftp-server enable
■ Use to enable the FTP server and to monitor the FTP port for attempts to connect
to the FTP server.
■ You can enable the FTP server on the default virtual router only.
■ Example
host1(config)#ftp-server enable
■ Use the no version to terminate current FTP sessions and to disable the FTP
server.
■ See ftp-server enable.
Configuration Example
Figure 23 on page 311 shows the scenario for this configuration example.
310 ■ Transferring Files
JUNOSe 11.1.x System Basics Configuration Guide

Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X Specifications

General

Brand	Juniper
Model	SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X
Category	Software
Language	English