Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X User Manual

■ Use the no version to disable the trap.
■ See bulkstats traps.
bulkstats virtual-router-group
■ Use to collect interface statistics for each virtual router.
■ A collector can have a maximum of 64 virtual routers associated with it.
■ Routers are identified by their assigned name or router index.
■ Supported only on if-stats and igmp schemas.
■ Supported on all interface types supported by the bulk statistics application.
■ Collectors modified to use per virtual router collection or configured after a
collector has started have a time delay until an active collector starts again.
■ Example
host1(config)#bulkstats virtual-router-group collector 2 routerISP3
■ Use the no version to prevent bulkstats from being reported for virtual router
groups.
■ See bulkstats virtual-router-group.
Deleting All Bulkstats Configurations
Although individual bulkstats commands allow you to disable or delete a specific
bulkstats parameter, the CLI also allows you to remove all bulkstats configurations
from the router at one time.
no bulkstats
Use to remove all bulkstats configurations from the router at one time.■
■ Example
host1(config)#no bulkstats
■ See no bulkstats.
Monitoring Collection Statistics
To view the parameters the router uses to collect statistics, use the following show
bulkstats commands.
To include or exclude lines of output based on a text string that you specify, use the
output filtering feature for show commands. For details, see “Command-Line
Interface” on page 29.
show bulkstats
204 ■ Collecting Bulk Statistics
JUNOSe 11.1.x System Basics Configuration Guide

Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X Specifications

General

Brand	Juniper
Model	SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X
Category	Software
Language	English