Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X User Manual

DHCP Local Pool Configuration Mode
In this mode, you can configure DHCP local pools. For example, you can specify a
DNS or NetBIOS server.
From Global Configuration mode, type the command ip dhcp-local pool and a
poolName, and then press Enter.
host1(config)#ip dhcp-local pool charlie
host1(config-dhcp-local)#?
default Set a command to its default(s)
default-router The default-router to use for this pool
dns-server The dns-server to use for this pool
do Run an exec mode command (alias command run)
domain-name The domain name for the pool
exit Exit from the current command mode
grace-period The grace period to be applied to leases
help Describe the interactive help system
lease The lease time for addresses from this pool
link Link to another DHCP Pool
log Configure logging settings
macro Run a CLI macro
netbios-name-server The netbios-name-server to use for this pool
netbios-node-type The netbios-node-type to use for this pool
network The network specified for this pool
no Negate a command or set its default(s)
reserve Reserve an ip address for a specific Mac Address
run Run an exec mode command (alias command do)
server-address The DHCP Server address to send to clients
sleep Make the Command Interface pause for a specified
duration
snmpTrap Enable snmp pool utilization traps
use-release-grace-period Apply the grace period to released leases
warning Configure utilization warnings
Domain Map Configuration Mode
In this mode, you can map a user domain name to a virtual router and loopback
interface.
From Global Configuration mode, type the aaa domain-map command and the
domain name value as found in the client’s login name. Then press Enter.
host1(config)#aaa domain-map charlie76
host1(config-domain-map)#?
address-pool-name Configure the address-pool-name for the domain name
atm Configure ATM parameters
default Set a command to its default(s)
do Run an exec mode command (alias command run)
exit Exit from the current command mode
help Describe the interactive help system
ip-hint Configure the IP hint feature for the domain
local-interface Configure the local interface value for remote clients
log Configure logging settings
loopback Configure the loopback interface to use when RX has an
unnumbered interface to the PPP client
macro Run a CLI macro
Accessing Command Modes ■ 93
Chapter 2: Command-Line Interface

Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X Specifications

General

Brand	Juniper
Model	SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X
Category	Software
Language	English