Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X

Setting the Console Speed
You can specify the console speed for only the current console session or for the
current console session and all subsequent console sessions.
speed
■ Use to set the speed for the current and all subsequent console sessions
immediately.
■ Example
host1(config)#line console 0
host1(config-line)#speed 14400
■ Use the no version to revert to the default, 9600 bps.
■ See speed.
terminal speed
■ Use to set the speed for the current console session.
■ Example
host1#terminal speed 14400
■ There is no no version.
■ See terminal speed.
Configuring the Display Terminal
You can specify the number of lines that appear on a terminal screen and the number
of characters that appear on a line.
terminal length
■ Use to set the number of lines on a screen.
■ If a command generates more lines than the number configured, the output
pauses after each screen.
■ Set the number of lines on a screen in the range 0–512.
■ Use 0 for no pausing.
■ Example
host1#terminal length 25
■ There is no no version.
■ See terminal length.
terminal width
282 ■ Customizing the User Interface
JUNOSe 11.1.x System Basics Configuration Guide