Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X User Manual

no Negate a command or set its default(s)
override-user Configure the username and password values to use instead
of the values from the remote client
padn Configure pppoe active discovery network parameters for
the domain name
router-name Configure the virtual-router for the domain name
run Run an exec mode command (alias command do)
sleep Make the Command Interface pause for a specified duration
strip-domain Configure the domain name stripping feature for the domain
tunnel Configure tunnel tag
virtual-router Configure the virtual-router for the domain name
Domain Map Tunnel Configuration Mode
In this mode, you can configure tunnel parameters such as the tunnel’s endpoint.
From Domain-Map Configuration mode, type tunnel and a tunnelNumber, and press
Enter.
host1(config-domain-map)#tunnel 17
host1(config-domain-map-tunnel)#?
address Configure tunnel endpoint address
client-name Configure the client hostname of the tunnel
default Set a command to its default(s)
exit Exit from the current command mode
do Run an exec mode command (alias command run)
help Describe the interactive help system
hostname Configure the client hostname of the tunnel
identification Configure tunnel identification
log Configure logging settings
macro Run a CLI macro
max-sessions Configure maximum sessions for this tunnel
medium Configure tunnel medium
no Negate a command or set its default(s)
password Configure tunnel password
preference Configure tunnel preference
run Run an exec mode command (alias command do)
server-name Configure the remote hostname for the tunnel
sleep Make the Command Interface pause for a specified duration
source-address Configure tunnel source address
type Configure tunnel type
DoS Protection Group Configuration Mode
In this mode, you can configure parameters for Denial of Service (DoS) protection
groups.
From Global Configuration mode, type the dos-protection-group command and
press Enter.
host1(config)#dos-protection-group
host1(config-dos-protection)#?
default Set a command to its default(s)
do Run an exec mode command (alias command run)
exit Exit from the current command mode
help Describe the interactive help system
log Configure logging settings
macro Run a CLI macro
94 ■ Accessing Command Modes
JUNOSe 11.1.x System Basics Configuration Guide

Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X Specifications

General

Brand	Juniper
Model	SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X
Category	Software
Language	English