Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X User Manual

first:
34563037
% De-activation failed.
The command fails because hf63037.hfx is dependent on hf63036.hfx.
Interdependent hotfixes must be deactivated and disarmed in the reverse order that
they were activated.
When 6-0-1p0-5.rel is re-armed and the router reloaded, the hotfix loader determines
that the startup hotfixes, hf63036.hfx and hf63037.hfx, are incompatible with the
release. It disarms these hotfixes. The user decides to delete the now unnecessary
hotfixes from the router.
host1# delete hf63036.hfx
host1# delete hf63037.hfx
host1# dir
Active System Controller:
unshared in
file size size date (UTC) use
------------------------- --------- --------- ------------------- ---
reboot.hty 596288 596288 03/07/2005 19:35:52
system.log 6762 6762 03/07/2005 17:30:08
haIpSetup.mac 4874 4874 03/24/2004 10:02:08
6-0-1p0-5.rel 125987342 125987342 02/30/2005 18:17:32 !
6-1-0.rel 148489185 148412851 02/28/2005 20:19:20
hf63035.hfx 30445 30445 03/07/2005 14:04:02 !
host1# show hotfix detail
name active armed requires
----------- ------------ ----- --------
hf63035.hfx X X ---
Managing the Ethernet Port on the SRP Module
You can configure the Fast Ethernet management port to access the router from a
Telnet session or SNMP.
On ERX7xx models, ERX14xx models, and ERX310 router, the Fast Ethernet port
is located on the SRP I/O module. For more information about configuring the Fast
Ethernet port on an SRP I/O module, see ERX Hardware Guide, Chapter 7, Accessing
ERX Routers.
Use the Fast Ethernet port on the SRP I/O module only as a router management port.
Do not use this port to route traffic for Fast Ethernet or higher-level protocols such
as transport or routing protocols, because doing so affects the performance of the
router.
On the E120 and E320 routers, the Fast Ethernet port is located on the SRP IOA. For
more information about configuring the Fast Ethernet port on an SRP IOA, see E120
and E320 Hardware Guide, Chapter 7, Accessing E Series Routers.
interface fastEthernet
402 ■ Managing the Ethernet Port on the SRP Module
JUNOSe 11.1.x System Basics Configuration Guide

Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X Specifications

General

Brand	Juniper
Model	SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X
Category	Software
Language	English