Root Directory OK
Checking File Space
Please Wait...
Checking Free Space
Please Wait...
PCMCIA Card Scan successful!
■ There is no no version.
■ See flash-disk scan.
Monitoring Flash Cards
Use the show nvs command to monitor the status of NVS on the primary SRP module.
Use the show flash command to view information about the flash card.
show flash
■ Use to display information about the flash card.
■ Field descriptions
■ Active System Controller—Information for flash cards on the active SRP
module
■ disk0—Flash card installed in slot 0 of the SRP module
■ disk1—Flash card installed in slot 1 of the SRP module; available only on
SRP modules for the E120 and E320 routers
■ Manufacturer—Name of manufacturer of the installed flash card
■ Capacity—Total capacity of the flash card, in bytes
■ Standby System Controller—Information for flash cards on the standby SRP
module
■ Example
host1#show flash
Active System Controller:
-------------------------
Device Manufacturer Capacity Status
------ -------------- ---------- -------
disk0 SILICONSYSTEMS 1047126528 mounted
disk1 STI 1024966656 mounted
Standby System Controller:
--------------------------
Device Manufacturer Capacity Status
------------- -------------- ---------- -------
standby-disk0 SILICONSYSTEMS 1047674880 mounted
standby-disk1 SILICONSYSTEMS 1047674880 mounted
■ See show flash.
show nvs
Managing Flash Cards on SRP Modules ■ 391
Chapter 6: Managing Modules
To Next Page
Loading...