Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X User Manual

From Global Configuration mode, type the l2tp switch-profile command followed
by an alphanumeric profile name of up to 64 characters, and press Enter.
host1(config)#l2tp switch-profile concord
host1(config-l2tp-tunnel-switch-profile)#?
avp Configure AVP behavior
default Set a command to its default(s)
do Run an exec mode command (alias command run)
exit Exit from the current command mode
help Describe the interactive help system
log Configure logging settings
macro Run a CLI macro
no Negate a command or set its default(s)
run Run an exec mode command (alias command do)
sleep Make the Command Interface pause for a specified duration
Layer 2 Control Configuration Mode
In this mode, you can define session timeout values and access the L2C Neighbor
Configuration mode to specify the L2C neighbor.
From Global Configuration mode, type l2C and press Enter.
host1(config)#l2c
host1(config-l2c)#?
default Set a command to its default(s)
do Run an exec mode command (alias command run)
exit Exit from the current command mode
help Describe the interactive help system
log Configure logging settings
macro Run a CLI macro
neighbor Configure l2c neighbor parameters
no Negate a command or set its default(s)
run Run an exec mode command (alias command do)
session-timeout Configure the l2c time-out attribute
sleep Make the Command Interface pause for a specified duration
Layer 2 Control Neighbor Configuration Mode
In this mode, you can specify a neighbor ID and the maximum number of branches
that the neighbor can have.
From Global Configuration mode, type neighbor and press Enter.
host1(config-l2c)#neighbor
host1(config-l2c-neighbor)#?
default Set a command to its default(s)
do Run an exec mode command (alias command run)
exit Exit from the current command mode
help Describe the interactive help system
id Configure neighbor-id associated with neighbor
log Configure logging settings
macro Run a CLI macro
max-branches Configure max number of branches for neighbor
no Negate a command or set its default(s)
run Run an exec mode command (alias command do)
sleep Make the Command Interface pause for a specified duration
104 ■ Accessing Command Modes
JUNOSe 11.1.x System Basics Configuration Guide

Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X Specifications

General

Brand	Juniper
Model	SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X
Category	Software
Language	English