Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X User Manual

Route Map Configuration Mode
In this mode, you can create and modify route maps.
From Global Configuration mode, type the route-map command and the appropriate
routeMapNumber, and press Enter.
host1(config)#route-map unis889
host1(config-route-map)#?
default Set a command to its default(s)
do Run an exec mode command (alias command run)
exit Exit from the current command mode
help Describe the interactive help system
log Configure logging settings
macro Run a CLI macro
match Identify this entry as requiring an attribute match
match-set Identify this entry to match and set attributes
no Negate a command or set its default(s)
run Run an exec mode command (alias command do)
set Configure this entry to set attributes
sleep Make the Command Interface pause for a specified duration
Router Configuration Mode
In this mode, you can configure a routing protocol using router commands.
From Global Configuration mode, type the router command and the appropriate
router attributes, and press Enter.
host1(config)#router bgp 2378
host1(config-router)#?
address-family Enter address family configuration mode
aggregate-address Create an aggregate entry in BGP routing table
auto-summary Automatic summarization of redistributed routes
to their natural network masks
bgp Configure BGP
default Set a command to its default(s)
default-fields Set default fields for show commands
default-information Configure the distribution of default routing
information
disable-dynamic-redistribute disable dynamic importing of routing
information with the latest policy
distance Configure administrative distances for routes
do Run an exec mode command (alias command run)
exit Exit from the current command mode
help Describe the interactive help system
ip Configure the type of route to be contributed
by this BGP address family
limits Configure limits on internal BGP tables
log Configure logging settings
macro Run a CLI macro
maximum-paths Configure the maximum number of equal-cost paths
neighbor Specify neighbor properties
network Identify a network for BGP to announce
no Negate a command or set its defaults
overload Configure BGP behaviour when reaching overload
state (no more resources available)
116 ■ Accessing Command Modes
JUNOSe 11.1.x System Basics Configuration Guide

Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X Specifications

General

Brand	Juniper
Model	SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X
Category	Software
Language	English