Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X - Appendix B References; Rfcs; Table 55: E Series Rfcs

Appendix B
References
This document lists RFCs, draft RFCs, other software standards, hardware standards,
and other references that provide information about the protocols and features
supported by the system.
■ RFCs on page 571
■ Draft RFCs on page 584
■ Other Software Standards on page 587
■ Hardware Standards on page 590
RFCs
Table 55: E Series RFCs
Protocol or FeatureReference
L2TPRFC 4951—Fail Over Extensions for Layer 2 Tunneling Protocol (L2TP)
"failover" (August 2007)
BGPRFC 4893—BGP Support for Four-octet AS Number Space (May 2007)
MPLSRFC 4816—Pseudowire Emulation Edge-to-Edge (PWE3) Asynchronous
Transfer Mode (ATM) Transparent Cell Transport Service (February
2007)
MPLSRFC 4875—Extensions to Resource Reservation Protocol - Traffic
Engineering (RSVP-TE) for Point-to-Multipoint TE Label Switched Paths
(LSPs) (May 2007)
VPLSRFC 4762—Virtual Private LAN Service (VPLS) Using Label Distribution
Protocol (LDP) Signaling (January 2007)
BGP/MPLS VPNsRFC 4684—Constrained Route Distribution for Border Gateway
Protocol/MultiProtocol Label Switching (BGP/MPLS) Internet Protocol
(IP) Virtual Private Networks (VPNs) ( 2006)
RADIUSRFC 4679—DSL Forum Vendor-Specific RADIUS Attributes
(September 2006)
MPLSRFC 4661—Signaling Requirements for Point-to-Multipoint
Traffic-Engineered MPLS Label Switched Paths (LSPs) (April 2006)
RFCs ■ 571