Command-Line Prompts
Within the CLI, the command-line prompt identifies both the hostname and the
command mode. The hostname is the name of your router; the command mode
indicates your location within the CLI system.
For example:
Keywords and Parameters
CLI commands are made up of two primary elements: keywords and parameters.
Keywords
Every command requires at least one keyword; however, a command can contain
other optional keywords. The keyword(s) must be typed into the CLI accurately for
it to be recognized. These are examples of keywords:
reload
run
router
map-class
map-list
clear ip isis redistribution
show vlan subinterface
qos-port-type-profile
no rtr reset
radius calling-station-delimiter
You can abbreviate keywords; however, you must enter enough initial characters to
unambiguously identify the command. For example, if the keyword you want to
specify is map-class and you enter only map-, an error appears. The error indicates
that one or more possible keywords begin with map-, thus making your entry
ambiguous.
Overview â– 31
Chapter 2: Command-Line Interface
To Next Page
Loading...
Need help?
General
