Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X User Manual

Subsequent use of the same command on any interface (in the following example,
Atm) on the same router without the table-type keyword compresses the
interface only in the ipNetToMedia table (not in interface or interface stack tables):
host1(config)#snmp-server interfaces compress Atm
■ Example 3—To compress interfaces based on the table types, interface-tables
and interface-stack-tables, use the following CLI example. In this example, the
Atm interface is compressed in interface tables (ifTables) and the Ds1 interface
is compressed in interface stack tables (ifStackTables), but none of the interfaces
are compressed in the ipNetToMediaTable.
host1(config)#snmp-server interfaces compress ?
[interfaceList]
table-type Category of SNMP tables from which to remove
< cr >
host1(config)#snmp-server interfaces compress atm table-type ?
interface-stack-tables Compression will be applicable to
ifStackTable/ifInvStackTable/juniIfStackTable
interface-tables Compression will be applicable to
ifTable/ifXtable/juniIfTable
host1(config)#snmp-server interfaces compress atm table-type interface-tables
host1(config)#snmp-server interfaces compress Ds1 table-type
interface-stack-tables
Router#show snmp interfaces
Compressed(Removed) Interface Types :
From ipNetToMediaTable:
From ifTables : Atm
From ifStackTables : Ds1
Armed Interface Numbering Mode: Sparse ifIndex
Interface Description Setting: Proprietary
■ Use the no version to add interface sublayers to the interface tables.
■ See snmp-server interfaces compress.
snmp-server interfaces compress-restriction
■ Use to exclude interfaces from the ifTable, the ifStackTable, and the ipAddrTable
if the administrative status of the interface is down.
■ Example
host1(config)#snmp-server interfaces compress-restriction ifadminstatusdown
■ Use the no version to remove the restriction and allow interfaces with an
administrative status of down in the ifTable, the ifStackTable, and the
ipAddrTable.
■ See snmp-server interfaces compress-restriction.
Controlling Interface Numbering
Each interface in the ifTable is assigned an ifIndex number. RFC 1213 required that
ifIndexes use contiguous integers and that the ifIndex be less than the value of the
SNMP Configuration Tasks ■ 165
Chapter 4: Configuring SNMP

Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X Specifications

General

Brand	Juniper
Model	SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X
Category	Software
Language	English