Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X User Manual

atm-vc ATM-VC interface
bridge Bridge interface
default Set a command to its default(s)
do Run an exec mode command (alias command run)
ethernet Ethernet interface
exit Exit from the current command mode
fr-vc Frame Relay subinterface
help Describe the interactive help system
ip IP interface
ip-tunnel IP FROM-tunnel interface
l2tp-tunnel L2tp FROM-tunnel interface
log Configure logging settings
lsp Lsp (MPLS) interface
macro Run a CLI macro
no Negate a command or set its default(s)
run Run an exec mode command (alias command do)
serial Serial interface
server-port Server Port interface
sleep Make the Command Interface pause for a specified duration
svlan Stacked VLAN subinterface
vlan VLAN subinterface
QoS Shared Shaper Control Configuration
In this mode, you can configure variables within the simple shared shaper algorithm
to control the minimum dynamic rate for all simple shared shapers on the router.
From Global Configuration mode, type the qos-shared-shaper-control command
and press Enter.
host1(config)#qos-shared-shaper-control
host1(config-qos-shared-shaper-control)#?
convergence-factor Configure how quickly the simple shared shaper
converges to a calculated rate
default Set a command to its default(s)
do Run an exec mode command (alias command run)
exit Exit from the current command mode
help Describe the interactive help system
log Configure logging settings
macro Run a CLI macro
maximum-voql Configure the simple shared shaper's maximum
virtual output queue length
minimum-dynamic-rate-percent Configure the minimum dynamic rate for a simple
shared shaper as a percentage of the
shared-shaping-rate
no Negate a command or set its default(s)
reaction-factor Configure how the simple shared shaper reacts
to changes in measured rate
run Run an exec mode command (alias command do)
sleep Make the Command Interface pause for a
specified duration
Queue Profile Configuration Mode
In this mode, you can configure queue profiles and various queue profile parameters,
such as constraints on queue lengths or queue buffer weights.
112 ■ Accessing Command Modes
JUNOSe 11.1.x System Basics Configuration Guide

Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X Specifications

General

Brand	Juniper
Model	SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X
Category	Software
Language	English