Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X User Manual

host1(config)#router rip 100
host1(config-router)#address-family ?
ipv4 Configure IPv4 address family
ATM VC Configuration Mode
In this mode, you can configure individual attributes for an ATM data PVC. These
attributes include the service category, encapsulation method, Inverse Address
Resolution Protocol (Inverse ARP), and F5 Operation, Administration, and
Management (OAM) parameters.
From Global Configuration mode, type the interface command and specify the ATM
subinterface identifier to enter Subinterface Configuration mode. From Subinterface
Configuration mode, type the pvc command and specify the virtual circuit descriptor
(VCD), virtual path identifier (VPI) and virtual circuit identifier (VCI) values (in the
format vpi/vci), and then press Enter.
host1(config)#interface atm 3/2.1
host1(config-subif)#pvc 100 0/100
host1(config-subif-atm-vc)#?
cbr Configure the Constant Bit Rate (CBR) service class
class-vc Assign a Virtual Circuit class to the Permanent Virtual
Circuit
default Set a command to its default(s)
do Run an exec mode command (alias command run)
encapsulation Configure the ATM encapsulation
exit Exit from the current command mode
help Describe the interactive help system
inarp Configure the Inverse Address Resolution Protocol (InARP)
protocol
log Configure logging settings
macro Run a CLI macro
no Negate a command or set its default(s)
oam Configure Operations, Administration, and Management (OAM)
oam-pvc Configure Operations, Administration, and Management (OAM) for
Permanent Virtual Circuit (PVC)
run Run an exec mode command (alias command do)
sleep Make the Command Interface pause for a specified duration
ubr Configure the Unspecified Bit Rate (UBR) service class
vbr-nrt Configure the Variable Bit Rate Non-Real Time (VBR-nrt)
service class
vbr-rt Configure the Variable Bit Rate Real Time (VBR-rt) service
class
ATM VC Class Configuration Mode
In this mode, you can configure a class of attributes for an ATM data PVC. The VC
class can include attributes for the service category, encapsulation method, F5 OAM
options, and Inverse ARP. You then apply the set of attributes as a group by assigning
the VC class to an individual PVC, to all PVCs created on a specified ATM major
interface, to all PVCs created on a specified ATM 1483 subinterface, or to a base
profile from which bulk-configured VC ranges are dynamically created.
From Global Configuration mode, type the vc-class atm command followed by an
alphanumeric VC class name of up to 32 characters, and press Enter.
90 ■ Accessing Command Modes
JUNOSe 11.1.x System Basics Configuration Guide

Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X Specifications

General

Brand	Juniper
Model	SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X
Category	Software
Language	English