Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X User Manual

Map Class Configuration Mode
In this mode, you can specify Frame Relay End-to-End fragmentation and reassembly
for a map class. Optionally, you can specify the maximum payload size of a fragment
or specify fragmentation only or reassembly only.
From Global Configuration mode, type the map-class frame-relay command and
the mapClassName you want to configure, and press Enter.
host1(config)#map-class frame-relay testmapclass
host1(config-map-class)#?
default Set a command to its default(s)
do Run an exec mode command (alias command run)
exit Exit from the current command mode
frame-relay Configure frame relay parameters
help Describe the interactive help system
log Configure logging settings
macro Run a CLI macro
no Negate a command or set its default(s)
run Run an exec mode command (alias command do)
sleep Make the Command Interface pause for a specified duration
Map List Configuration Mode
In this mode, you can configure map list parameters. In Map List Configuration mode,
commands such as map-list and ip atm-vc are used to configure ATM NBMA
interfaces.
From Global Configuration mode, type map-list and a mapListName, and press Enter.
host1(config)#map-list mjt3330
host1(config-map-list)#?
default Set a command to its default(s)
do Run an exec mode command (alias command run)
exit Exit from the current command mode
help Describe the interactive help system
ip Add IP address to the map
log Configure logging settings
macro Run a CLI macro
no Negate a command or set its default(s)
run Run an exec mode command (alias command do)
sleep Make the Command Interface pause for a specified duration
Parent Group Configuration Mode
In this mode, you can configure a parent group in a hierarchy.
From Global Configuration mode, type the parent-group command and specify a
parentGroupName, and press Enter.
host1(config)#parent-group group1
host1(config-parent-group)#?
default Set a command to its default(s)
do Run an exec mode command (alias command run)
exit Exit from the current command mode
Accessing Command Modes ■ 107
Chapter 2: Command-Line Interface

Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X Specifications

General

Brand	Juniper
Model	SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X
Category	Software
Language	English