Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X

To display the configuration:
host1#show dos-protection-group default
default (canned-group: defaultCanned) *modified -- no references
Protocol Dest Mod Rate Burst Weight DropProb Priority Skip
-------------------- ---- --- ----- ----- ------ -------- --------- ----
Ppp Echo Request IC - 2048 1024 100 100 HI green Y
Ppp Echo Reply IC - 2048 1024 100 100 HI green Y
Ppp Echo Reply Fastp FC - 0 0 100 100 Data path Y
path
Ppp Control IC - 2048 1024 100 100 HI green N
Atm Control (ILMI) IC - 2048 1024 100 100 HI green Y
Atm OAM IC * 512 512 100 100 LO green N
Atm Dynamic Interfac IC - 1024 512 100 100 HI yellow N
e Column Creation
Atm Inverse ARP IC - 256 128 100 100 LO yellow N
Frame Relay Control IC - 2048 1024 100 100 HI green Y
(LMI)
Frame Relay Inverse IC - 256 128 100 100 LO yellow N
Arp
Pppoe Control IC * 512 512 100 100 HI yellow N
Pppoe Ppp Config Dyn IC - 1024 512 100 100 HI yellow N
amic Interface Colum
n Creation
Ethernet ARP Miss IC - 256 128 100 100 LO yellow N
Ethernet ARP IC - 256 128 100 100 LO yellow N
DoS Protection Group Commands
Use the commands described in this section to create DoS protection groups and
attach them to different types of interfaces with the atm dos-protection-group
command.
■ Use to attach an ATM DoS protection group to an interface.
■ Example
host1(config-if)#atm dos-protection-group group1
■ Use the no version to remove the attachment of the DoS protection group from
the interface.
bridge1483 dos-protection-group
■ Use to attach a bridge 1483 DoS protection group to an interface.
■ Example
host1(config-if)#bridge1483 dos-protection-group group1
■ Use the no version to remove the attachment of the DoS protection group from
the interface.
■ See bridge1483 dos-protection-group.
dos-protection-group
466 ■ Denial of Service (DoS) Protection
JUNOSe 11.1.x System Basics Configuration Guide