Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X User Manual

host1(config)#policy-list grouppol1
host1(config-policy-list)#parent-group group1
host1(config-policy-list-parent-group)#?
default Set a command to its default(s)
do Run an exec mode command (alias command run)
exit Exit from the current command mode
help Describe the interactive help system
log Configure logging settings
macro Run a CLI macro
no Negate a command or set its default(s)
rate-limit-profile Specify the hierarchical rate limit profile
run Run an exec mode command (alias command do)
sleep Make the Command Interface pause for a specified
Policy Parameter Configuration Mode
In this mode, you can configure a policy parameter.
From Global Configuration mode, type the policy-parameter command and specify
a policyParameterType, the hierarchical keyword, and press Enter.
host1(config)#policy-parameter param1 hierarchical
host1(config-policy-parameter)#?
aggregation-node Configure the aggregation node value
default Set a command to its default(s)
do Run an exec mode command (alias command run)
exit Exit from the current command mode
help Describe the interactive help system
log Configure logging settings
macro Run a CLI macro
no Negate a command or set its default(s)
run Run an exec mode command (alias command do)
sleep Make the Command Interface pause for a specified time
PPPoE Service Name Table Configuration Mode
In this mode, you can configure entries for a PPPoE service name table. PPPoE clients
use these entries to request that an access concentrator (AC), such as an E Series
router, support certain services. Issue the service command from this mode to
configure a specific service name entry, or to specify that the AC should ignore (drop),
rather than respond to (terminate, the default action), a PPPoE Active Discovery
Initiation (PADI) request from a client containing the empty service name tag.
From Global Configuration mode, type the pppoe-service-name-table command
followed by an alphanumeric table name of up to 32 characters, and press Enter.
host1(config)#pppoe-service-name-table serviceTable1
host1(config-pppoe-service-name-table)#?
default Set a command to its default(s)
do Run an exec mode command (alias command run)
exit Exit from the current command mode
help Describe the interactive help system
log Configure logging settings
macro Run a CLI macro
no Negate a command or set its default(s)
run Run an exec mode command (alias command do)
Accessing Command Modes ■ 109
Chapter 2: Command-Line Interface

Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X Specifications

General

Brand	Juniper
Model	SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X
Category	Software
Language	English