Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X User Manual

Flow Cache Configuration Mode
In this mode, you can configure parameters for the aggregation cache.
From Global Configuration mode, type the ip flow-aggregation cache command
and press Enter.
host1(config)#ip flow-aggregation cache
host1(config-flow-cache)#?
cache Configure Flow Stats cache parameters
default Set a command to its default(s)
do Run an exec mode command (alias command run)
enabled Start flow cache operation
exit Exit from the current command mode
export Configure Flow-Cache export parameters
help Describe the interactive help system
log Configure logging settings
macro Run a CLI macro
no Negate a command or set its default(s)
run Run an exec mode command (alias command do)
sleep Make the Command Interface pause for a specified duration
Interface Configuration Mode
From Interface Configuration mode, you can enable many system features for each
interface you create. Interface Configuration commands allow you to:
■ Create an interface.
■ Modify the operation of an interface.
■ Access Subinterface Configuration mode.
From Global Configuration mode, type interface and identify the interface you want
to configure and press Enter.
host1(config)#interface atm 0/1
host1(config-if)#
The CLI is now in Interface Configuration mode.
host1(config)#interface ?
atm ATM interface
fastEthernet IEEE 802.3 fastEthernet interface
gigabitEthernet IEEE 802.3 gigabitEthernet interface
hssi High Speed Serial interface
ip Ip shared interface
ipv6 Ipv6 shared interface
lag Link Aggregation interface
loopback Loopback interface
mlframe-relay Multilink frame-relay interface
mlppp Multilink PPP interface
null Null interface
pos Packet over SONET interface
serial Serial interface
tunnel Tunnel interface
96 ■ Accessing Command Modes
JUNOSe 11.1.x System Basics Configuration Guide

Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X Specifications

General

Brand	Juniper
Model	SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X
Category	Software
Language	English