Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X User Manual

Table 27: Policy Schema Objects (continued)
DefinitionObject
Configure policy schema for red packetsred-packets
Configure policy schema for upper green bytesupper-green-bytes
Configure policy schema for upper green packetsupper-green-packets
Configure policy schema for upper red bytesupper-red-bytes
Configure policy schema for upper red packetsupper-red-packets
Configure policy schema for upper yellow bytesupper-yellow-bytes
Configure policy schema for upper yellow packetsupper-yellow-packets
Configure policy schema for yellow bytesyellow-bytes
Configure policy schema for yellow packetsyellow-packets
QoS Schema Objects
Table 28 on page 218 describes QoS objects that you can configure using the bulkstats
schema subtree qos command. For more information about QoS objects, see the
JUNOSe Quality of Service Configuration Guide
Table 28: QoS Schema Objects
DefinitionObject
Configure QoS schema to export the average drop rate
within the rate period specified in the statistics profile of
the egress queue
aggregate-drop-rate
Configure QoS schema to export all statistics; this is the
default option
all
Configure QoS schema to export the assured rate attributeassured-rate
Configure QoS schema to export the burst attributeburst
Configure QoS schema to export the number of bytes
configured for the byte-adjustment application, if the
byte-adjustment application is enabled on the queue
byte-adjustment-bytes
Configure QoS schema to export the type of
byte-adjustment, if byte-adjustment is enabled on the
queue
byte-adjustment-rate
Configure QoS schema to export the drop profile name
associated with the queue
drop-profile
218 ■ Collecting Bulk Statistics
JUNOSe 11.1.x System Basics Configuration Guide

Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X Specifications

General

Brand	Juniper
Model	SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X
Category	Software
Language	English