Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X User Manual

Overview
Managing the E Series router involves a variety of tasks. This chapter covers those
tasks associated with the router in general rather than specific networking protocols.
Each section in the chapter covers a different topic; where appropriate, a section
contains an overview of the topic, configuration tasks, and information about
monitoring the associated settings.
For additional management information, CLI commands, and procedures, refer to
the following table.
ReferenceTask
JUNOSe Command Reference GuideFind detailed information about
commands described in this chapter.
“Configuring SNMP” on page 147Configure the system as an SNMP agent.
“Managing the System” on page 251Set system passwords.
“Managing Modules” on page 355Write CLI macros.
“Booting the System” on page 509Boot the system.
“Managing Modules” on page 355Manage line modules and SRP modules.
Platform Considerations
System management is supported on all E Series routers.
For information about the modules supported on E Series routers:
■ See the ERX Module Guide for modules supported on ERX7xx models, ERX14xx
models, and the ERX310 Broadband Services Router.
■ See the E120 and E320 Module Guide for modules supported on the E120 and
E320 Broadband Services Routers.
Naming the System
When you receive the router, it has a factory default host name. To rename the
router, use the hostname command.
hostname
■ Use to rename the router.
■ The assigned name is displayed in the command-line interface (CLI) prompts.
■ Example
252 ■ Overview
JUNOSe 11.1.x System Basics Configuration Guide

Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X Specifications

General

Brand	Juniper
Model	SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X
Category	Software
Language	English