Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X User Manual

From Global Configuration mode, type the qos-interface-superset command followed
by an interfaceSupersetName, and press Enter.
host1(config)#qos-interface-superset voice
host1(config-interface-set)#?
default Set a command to its default(s)
do Run an exec mode command (alias command run)
exit Exit from the current command mode
help Describe the interactive help system
log Configure logging settings
macro Run a CLI macro
no Negate a command or set its default(s)
qos-interface-parent Define parent of the interface set
qos-parameter Instantiate a QoS parameter for this interface
qos-profile Attach/Detach a qos-profile
restricted Define restricted interface
run Run an exec mode command (alias command do)
sleep Make the Command Interface pause for a specified
duration
QoS Parameter Definition Configuration Mode
In this mode, you can configure QoS parameter definitions.
From Global Configuration mode, type the qos-parameter-define command followed
by a QosParameterDefinitionName, and press Enter.
host1(config)#qos-parameter-define vpSharedShaper1
host1(config-qos-parameter-define)#?
controlled-interface-type Configure the valid interface types controlled by
this parameter
default Set a command to its default(s)
do Run an exec mode command (alias command run)
exit Exit from the current command mode
help Describe the interactive help system
instance-interface-type Configure the interface types upon which
parameters can be instantiated
log Configure logging settings
macro Run a CLI macro
no Negate a command or set its default(s)
range Set the valid range of a QoS parameter
run Run an exec mode command (alias command do)
sleep Make the Command Interface pause for a specified
duration
subscriber-interface-type Configure interface types representing subscriber
interfaces
QoS Profile Configuration Mode
In this mode, you can specify queue profiles and scheduler profiles in combination
with interface types.
From Global Configuration mode, type the qos-profile command followed by a
QosProfileName, and press Enter.
host1(config)#qos-profile testabc
host1(config-qos-profile)#?
atm ATM interface
Accessing Command Modes ■ 111
Chapter 2: Command-Line Interface

Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X Specifications

General

Brand	Juniper
Model	SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X
Category	Software
Language	English