Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X User Manual

From Global Configuration mode, type ipsec tunnel profile and the profileName,
and press Enter.
host1(config)#ipsec tunnel profile profile1
host1(config-ipsec-tunnel-profile)#?
default Set a command to its default(s)
do Run an exec mode command (alias command run)
domain-suffix Configure a domain suffix to be appended to users on
this profile
exit Exit from the current command mode
extended-authentication Configure extended authentication parameters
help Describe the interactive help system
ike Configure IKE characteristics
ip Configure local IP characteristics
lifetime Configure the phase 2 life parameters
local Configure local characteristics
log Configure logging settings
macro Run a CLI macro
max-interfaces Configure the maximum allowed dynamic interface
instantiations
no Negate a command or set its default(s)
peer Configure peer characteristics
pfs Configure the phase 2 perfect forward secrecy
run Run an exec mode command (alias command do)
sleep Make the Command Interface pause for a specified
duration
transform Configure the phase 2 transforms allowed on this
IPSEC tunnel profile
tunnel Configure tunnel parameters
IP Tunnel Destination Profile Mode
In this mode, you can specify parameters for GRE or DVMRP dynamic tunnels.
From Global Configuration mode, type gre destination profile or dvmrp destination
profile and the destination profile name, and press Enter.
host1(config)#gre destination profile global
host1(config-dest-profile)#?
default Set a command to its default(s)
do Run an exec mode command (alias command run)
enable Enable a tunnel parameter
exit Exit from the current command mode
help Describe the interactive help system
log Configure logging settings
macro Run a CLI macro
no Negate a command or set its default(s)
profile Assign a profile
run Run an exec mode command (alias command do)
sleep Make the Command Interface pause for a specified duration
tunnel Configure a tunnel parameter
host1(config)#dvmrp destination profile global
host1(config-dest-profile)#?
default Set a command to its default(s)
do Run an exec mode command (alias command run)
enable Enable a tunnel parameter
exit Exit from the current command mode
help Describe the interactive help system
log Configure logging settings
Accessing Command Modes ■ 101
Chapter 2: Command-Line Interface

Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X Specifications

General

Brand	Juniper
Model	SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X
Category	Software
Language	English