Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X

Monitoring DoS Protection Groups
Use the commands described in this section to monitor DoS protection groups.
show dos-protection-group
■ Use to display DoS protection groups.
■ If you do not specify a group, displays the names of the currently configured
DoS protection groups.
■ If you specify a group, displays information about the specified group.
■ If you do not specify the brief keyword, displays a list of references (interfaces
and templates) to the DoS protection group,
■ When *modified* appears next to the name of the DoS protection group. the
group or protocol within the group has changed from the preprogrammed value
of the associated group.
■ Example
host1(config)#show dos-protection-group
DOS Protection Groups:
Default (canned-group: “ default” ) *modified*
Uplink (canned-group: “ link” }
ATM (canned-group: “ pppoe” ) *modified*
VLAN (canned-group: “ mixed-access” )
■ See show dos-protection-group.
472 ■ Denial of Service (DoS) Protection
JUNOSe 11.1.x System Basics Configuration Guide