Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X User Manual

no aaa new-model
no service ctrl-x-reboot
no service password-encryption
no baseline show-delta-counts
clock timezone UTC 0 0
no exception dump
exception protocol ftp anonymous null
controller sonet 2/0
sdh
loopback network
clock source line
no shutdown
path 0 overhead j1 msg hello
path 0 overhead j1 exp-msg
ftp-server enable
no login
log engineering
log verbosity low
no log severity
log verbosity low NameResolverLog
log verbosity low aaaAtm1483Cfg
log verbosity low atm1483
log verbosity low atmAal5
log verbosity low bgpConnections
log verbosity low bgpDampening
log verbosity low bgpEng1
log verbosity low bgpEngineering
log verbosity low bgpEvents
log verbosity low bgpKeepAlives
no log engineering
log fields timestamp instance no-calling-task
timing select primary
timing source primary internal
timing source secondary internal
timing source tertiary internal
no atm aal5 snmp trap link-status
no atm aal5 shutdown
interface atm 2/0.1 point-to-point
no shutdown
no atm atm1483 shutdown
no atm atm1483 snmp trap link-status
ip route 0.0.0.0 0.0.0.0 10.13.5.1
ip debounce-time 0
ip source-route
Redirection of show Command Output
You can redirect the output of show commands to network files or local files (in NVS
memory) using the redirection operators described in Table 4 on page 40 .
Table 4: Redirect Operators
UseRedirect Operator
Redirects output to the specified file, overwriting the file if
it already exists, creating the file if it does not.
>
Appends output to the end of the specified file, creating the
file if it does not exist.
>>
40 ■ Overview
JUNOSe 11.1.x System Basics Configuration Guide

Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X Specifications

General

Brand	Juniper
Model	SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X
Category	Software
Language	English