Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X User Manual

SNMP Configuration Tasks
To configure the SNMP server:
1. Enable the SNMP server.
host1(config)#snmp-server
2. Configure at least one authorized SNMP community (SNMPv1/v2c) or user
(SNMPv3), which provides SNMP client access.
host1(config)#snmp-server community boston view everything rw
host1(config)#snmp-server user fred group private auth sha fred-password priv
des password
3. (Optional) Set the server parameters—contact name and server location.
host1(config)#snmp-server contact Bob Smith
host1(config)#snmp-server location 3rdfloor
4. (Optional) Reconfigure the maximum SNMP packet size.
host1(config)#snmp-server packetsize 1000
5. (Optional) Configure memory warning parameters.
host1(config)#memory warning 80 70
6. (Optional) Configure the method the router uses to encode the ifDescr and ifName
objects.
host1(config)#snmp interfaces description-format common
7. (Optional) Manage the interface sublayers (compress interfaces and control
interface numbering).
host1(config)#snmp-server interfaces compress atmAal5
host1(config)#snmp-server interface compress-restriction ifadminstatusdown
host1(config)#snmp interfaces rfc1213 55000 100000
8. (Optional) Configure the dynamic group parameters.
host1(config)#snmp-server group grp1authpriv usm priv read grp1read write
grp1write notify grp1notify
9. (Optional) Configure the dynamic view parameters.
host1(config)#snmp-server view view1 1.3.6.1 included non-volatile
You can also set up SNMP traps and set up the router to collect bulk statistics. See
“Configuring Traps” on page 167 and “Collecting Bulk Statistics” on page 195.
158 ■ SNMP Configuration Tasks
JUNOSe 11.1.x System Basics Configuration Guide

Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X Specifications

General

Brand	Juniper
Model	SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X
Category	Software
Language	English