Monitoring Schema Statistics
You are able to display your configuration and monitor the data generated by
schemas.
show bulkstats schema
■ Use to display data on the bulk statistics schema.
■ Field descriptions
■ Schema Information:
■ Index—Index number of the schema
■ Subtree—Type of bulk statistics schema configured on the collector: igmp,
if-stack, if-stats, policy, QoS, or system
■ CollectorIndex—Bulk statistics collector index (same as the SNMP table
index)
■ State
■ active—Schema is properly configured and currently active
■ notInService—Schema has been decommissioned by a management
client
■ notReady—Schema does not have enough configuration information to
go active
■ error—Configuration/operational error
■ Subtree List—Types of statistics the schema is configured to receive
■ Example 1—Displays bulk statistics information for a schema that is configured
to retrieve the if-stack and system information.
host1#show bulkstats schema
Schema Information:
Index Subtree CollectorIndex State
----- ----------------- -------------- --------
1 ifStack 1 active
2 system 2 active
Index Subtree List
----- -------------------------------------------------
1 N/A
2 N/A
■ Example 2—Displays bulk statistics configuration information for a schema that
is configured to retrieve interface usage information (specified by the ifstats
keyword) for the out-errors, lower-interface, and time-offset counters. The
schema is also configured for retrieving the global system and per-module
statistics information (specified by the system keyword).
Collecting Bulk Statistics ■ 235
Chapter 4: Configuring SNMP
To Next Page
Loading...