Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X User Manual

host1(config)#vc-class atm premium-subscriber-class
host1(config-vc-class)#?
cbr Configure the Constant Bit Rate (CBR) service class
default Set a command to its default(s)
do Run an exec mode command (alias command run)
encapsulation Configure the ATM encapsulation
exit Exit from the current command mode
help Describe the interactive help system
inarp Configure the Inverse Address Resolution Protocol (InARP)
protocol
log Configure logging settings
macro Run a CLI macro
no Negate a command or set its default(s)
oam Configure Operations, Administration, and Management (OAM)
oam-pvc Configure Operations, Administration, and Management (OAM) for
Permanent Virtual Circuit (PVC)
run Run an exec mode command (alias command do)
sleep Make the Command Interface pause for a specified duration
ubr Configure the Unspecified Bit Rate (UBR) service class
vbr-nrt Configure the Variable Bit Rate Non-Real Time (VBR-nrt)
service class
vbr-rt Configure the Variable Bit Rate Real Time (VBR-rt) service
class
Classifier Group Configuration Mode
In this mode, you can configure the set of rules for a classification group in a policy
list that you can attach to an interface.
From Policy List Configuration mode, type the classifier-group command and its
attributes, and then press Enter.
host1(config-policy-list)#classifier-group ipCLACL10 precedence 75
host1(config-policy-list-classifier-group)#?
color Create a color policy
default Set a command to its default(s)
do Run an exec mode command (alias command run)
exit Exit from the current command mode
filter Create a filter policy
forward Create a forward policy
help Describe the interactive help system
log Configure logging settings
macro Run a CLI macro
mark Create a set TOS byte policy
next-hop Create a next-hop policy
next-interface Create a next-interface policy
no Negate a command or set its default(s)
rate-limit-profile Create a rate-limit policy
run Run an exec mode command (alias command do)
sleep Make the Command Interface pause for a specified duration
suspend Suspend a policy rule
traffic-class Create a traffic class policy
user-packet-class Create a user packet class policy
Color Mark Profile Configuration Mode
In this mode, you can configure translation for a color to a type-dependent mark for
TOS or EXP for an IP, IPv6 or MPLS interface.
Accessing Command Modes ■ 91
Chapter 2: Command-Line Interface

Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X Specifications

General

Brand	Juniper
Model	SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X
Category	Software
Language	English