Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X User Manual

masked-key Enter a masked key (not for manual entry, show config generates)
no Negate a command or set its default(s)
run Run an exec mode command (alias command do)
sleep Make the Command Interface pause for a specified duration
IPSec Peer Public Key Configuration Mode
In this mode, you can configure the ISAKMP/IKE public key that a remote peer uses
for RSA authentication during the tunnel establishment phase without the need for
a digital certificate.
From Global Configuration mode, type ipsec key pubkey-chain rsa and either the
IP address or fully qualified domain name of the remote peer, and press Enter.
host1(config)#ipsec key pubkey-chain rsa address 192.168.50.5
host1(config-peer-public-key)#?
default Set a command to its default(s)
do Run an exec mode command (alias command run)
exit Exit from the current command mode
help Describe the interactive help system
key-string Enter key string
log Configure logging settings
macro Run a CLI macro
no Negate a command or set its default(s)
run Run an exec mode command (alias command do)
sleep Make the Command Interface pause for a specified duration
IPSec Transport Profile Configuration Mode
In this mode, you can configure an IP Security (IPSec) transport profile, which is used
for Layer 2 Tunneling Protocol (L2TP) over IPSec connections.
From the Global Configuration mode, type ipsec transport profile, the profileName,
virtual-router vrName, ip address ipAddress, and press Enter.
host1(config)#ipsec transport profile secureL2tp virtual-router default ip address 0.0.0.0
host1(config-ipsec-transport-profile)#?
application Configure the application type that is protected by the l2tp
default Set a command to its default(s)
do Run an exec mode command (alias command run)
exit Exit from the current command mode
help Describe the interactive help system
lifetime Configure the renegotiation time
local Configure local endpoint of the transport connection
log Configure logging settings
macro Run a CLI macro
no Negate a command or set its default(s)
pfs Configure perfect forward secrecy
run Run an exec mode command (alias command do)
sleep Make the Command Interface pause for a specified duration
transform-set Configure the transform set used by ipsec transport profile
IPSec Tunnel Profile Configuration Mode
In this mode, you can configure a profile of an IPSec tunnel.
100 ■ Accessing Command Modes
JUNOSe 11.1.x System Basics Configuration Guide

Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X Specifications

General

Brand	Juniper
Model	SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X
Category	Software
Language	English