Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X

NOTE: The privilege command is available in Line Configuration mode when the
user is logged in at privilege level 15. For more information, see “Privileged-Level
Access” on page 49 and “CLI Command Privileges” on page 52 .
Local IPSec Transport Profile Configuration
In this mode, you can configure preshared IKE keys for IPSec transport profiles.
From the IPSec Transport Profile Configuration mode, type local ip address and the
ipAddress, and press Enter.
host1(config-ipsec-transport-profile)#local ip address 10.10.1.1
host1(config-ipsec-transport-profile-local)#?
default Set a command to its default(s)
do Run an exec mode command (alias command run)
exit Exit from the current command mode
help Describe the interactive help system
log Configure logging settings
macro Run a CLI macro
no Negate a command or set its default(s)
pre-share Specify pre-shared group key based on local ip address
pre-share-masked A pre-encrypted key, generated by show config rather than
interactive
run Run an exec mode command (alias command do)
sleep Make the Command Interface pause for a specified duration
Local User Configuration Mode
In this mode, you can configure parameters for user entries in local user databases.
From the Global Configuration mode, type either aaa local username and the
userName and databaseName or aaa local database and the databaseName. Then
press Enter.
host1(config)#aaa local username curt38 database westLocal12
host1(config-local-user)#?
default Set a command to its default(s)
do Run an exec mode command (alias command run)
exit Exit from the current command mode
help Describe the interactive help system
ip-address Specify an IP address for the user
ip-address-pool Specify an IP address pool for the user
log Configure logging settings
macro Run a CLI macro
no Negate a command or set its default(s)
operational-virtual-router Specify an operational virtual router for the
user
password Configure the password
run Run an exec mode command (alias command do)
secret Configure the secret
sleep Make the Command Interface pause for a specified
duration
support Enter Support mode
106 ■ Accessing Command Modes
JUNOSe 11.1.x System Basics Configuration Guide