Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X User Manual

host1#disable
host1>
■ Example 2
host1#show privilege
Privilege level is 10
host1#disable 5
host1#show privilege
Privilege level is 5
■ There is no no version.
■ See disable.
Logging Out
You can log out of the CLI from either the User Exec and Privileged Exec modes by
entering the exit command. For example:
host1>exit
logging out.
or
host1#exit
logging out.
CLI Command Privileges
You can change the privilege level of most commands by using the privilege
command that is available in Global Configuration mode. To use this command, you
must enable your CLI session to privilege level 15.
CLI Privilege Groups
You can change privilege group accessibility. Privilege groups are no longer required
to be hierarchical. You can modify the privilege group membership and define which
privilege group is a member of another privilege group.
A privilege group can contain commands and other privilege groups as members. A
group always has access to commands in its own privilege group and in privilege
group 0. By default, all groups have one member and a specific privilege group has
access to all commands in all privilege groups with a lower number than the specific
group.
A privilege group is reachable from another privilege group when it is a member of
that privilege group, or a member of a group that is a member of that privilege group
until a search of all member groups is exhausted. This can go through several
recursions as long as there are no circular dependencies.
52 ■ CLI Command Privileges
JUNOSe 11.1.x System Basics Configuration Guide

Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X Specifications

General

Brand	Juniper
Model	SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X
Category	Software
Language	English