Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X - Table 10: Command Mode Overview

Table 10: Command Mode Overview
Exit from ModeAccess to ModeUse of ModeMode Name
■
Use the exit command to
return to Global Configuration
mode.
■
Press Ctrl+z to return to Exec
mode.
■
From Global
Configuration mode,
use aaa-profile
command.
■
Prompt:
host1(config-aaa-profile)#
■
Configure new AAA
profiles.
AAA Profile
Configuration
■
Use the exit command twice to
return to Global Configuration
mode.
■
Press Ctrl+z to return to Exec
mode.
■
From Global
Configuration mode,
use router bgp or
router rip to enter
Router Configuration
mode. From Router
Configuration, use the
address-family
command.
■
Prompt:
host1(config-router-af)#
■
Configure BGP or RIP
address family
parameters.
Address Family
Configuration
■
Use the exit command to
return to Global Configuration
mode.
■
Press Ctrl+z to return to Exec
mode.
■
From Global
Configuration mode,
use the vc-class atm
command, and specify
the name of the VC
class.
■
Prompt:
host1(config-vc-class)#
■
Configure a class of
attributes for an ATM
data PVC.
ATM VC Class
Configuration
■
Use the exit command twice to
return to Global Configuration
mode.
■
Press Ctrl+z to return to Exec
mode.
■
From Global
Configuration mode,
use the interface
command to enter
Subinterface
Configuration mode.
From Subinterface
Configuration mode,
use the pvc command.
■
Prompt:
host1(config-subif-atm-vc)#
■
Configure individual
attributes for an ATM
data PVC.
ATM VC Configuration
70 ■ Accessing Command Modes
JUNOSe 11.1.x System Basics Configuration Guide