Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X - Page 101

Table 10: Command Mode Overview (continued)
Exit from ModeAccess to ModeUse of ModeMode Name
■
Use the exit command twice to
return to Global Configuration
mode.
■
Press Ctrl+z to return to Exec
mode.
■
To create a classifier
group, from Policy List
Configuration mode use
the classifier-group
command and identify
the CLACL and
precedence.
■
Prompt:
host1(config-policy-list-
classifier-group)#
■
Configure classifier
groups with policy
rules used for policy
lists.
Classifier Group
Configuration
■
Use the exit command once to
return to Global Configuration
mode.
■
Press Ctrl+z to return to Exec
mode.
■
From Rate Limit Profile
Configuration Mode,
use the
color-mark-profile
command and identify
the interface type (IP,
IPv6, MPLS).
■
Prompt:
host1(config-color-mark-
profile)#
■
Configure packet color
after exit from
rate-limit hierarchy.
Color Mark Profile
Configuration
■
Use the exit command once to
return to Global Configuration
mode.
■
Press Ctrl+z to return to Exec
mode.
■
From Global
Configuration Mode,
use the control-plane
command.
■
Prompt:
host1(config-control-plane)#
■
Configure SRP module
policing.
Control Plane
Configuration
■
Use the exit command once to
return to Global Configuration
mode.
■
Press Ctrl+z to return to Exec
mode.
■
From Global
Configuration mode,
use the controller
command.
■
Prompt:
host1(config-controll)#
■
Configure physix`cal
interfaces (for
example, T3).
Controller Configuration
■
Use the exit command once to
return to Global Configuration
mode.
■
Press Ctrl+z to return to Exec
mode.
■
From Global
Configuration mode,
use the ip dhcp-local
pool command.
■
Prompt:
host1(config-dhcp-local)#
■
Configure DHCP local
pools.
DHCP
Local Pool Configuration
Accessing Command Modes ■ 71
Chapter 2: Command-Line Interface