Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X - Page 102

Table 10: Command Mode Overview (continued)
Exit from ModeAccess to ModeUse of ModeMode Name
■
Use the exit command once to
return to Global Configuration
mode.
■
Press Ctrl+z to return to Exec
mode.
■
From Global
Configuration mode,
use the aaa
domain-map
command.
■
Prompt:
host1(config-domain-map)#
■
Configure domain
maps.
Domain Map
Configuration
■
Use the exit command twice to
return to Global Configuration
mode.
■
Press Ctrl+z to return to Exec
mode.
■
From Domain-Map
Configuration mode,
use the tunnel
command.
■
Prompt:
host1(config-domain-m
ap-tunnel)#
■
Configure tunnel
parameters.
Domain Map
Tunnel Configuration
■
Use the exit command once to
return to Global Configuration
mode.
■
Press Ctrl+z to return to Exec
mode.
■
From Global
Configuration Mode,
use the
dos-protection-group
command.
■
Prompt:
host1(config-dos-group)#
■
Configure parameters
for DoS protection
groups.
DoS Protection Group
Configuration
■
Use the exit command once to
return to Global Configuration
mode.
■
Press Ctrl+z to return to Exec
mode.
■
From Global
Configuration mode,
use the drop-profile
command.
■
Prompt:
host1(config-drop-profile)#
■
Configure drop
profiles.
Drop Profile
Configuration
■
Use the exit command to
return to Global Configuration
mode.
■
Press Ctrl+z to return to Exec
mode.
■
From Global
Configuration mode,
specify the mpls
explicit-path name
command.
■
Prompt:
host1(config-expl-path)#
■
Configure MPLS
explicit path
parameters.
Explicit Path
Configuration
72 ■ Accessing Command Modes
JUNOSe 11.1.x System Basics Configuration Guide