Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X User Manual

The VSA Allow-All-VR-Access controls access; the VSA Virtual-Router controls the VR
to which the user logs in, and the VSA Alt-CLI-Virtual-Router-Name specifies which
VRs other than the VR specified by the VSA virtual-router are accessible to restricted
users. See Table 48 on page 448.
Table 48: Juniper Networks–Specific Virtual Router Access VSA Descriptions
Value
Subtype
LengthSubtypeLengthTypeDescriptionVSA
Integer:
0 – disable,
1 – enable
sublen19len26Specifies user
access to all
virtual
routers.
Allow-All-VR-Access
String:
virtual-router
-name
sublen1len26Specifies the
VR to which
the user logs
in or the only
VR to which a
user has
access. The
default setting
is the default
VR.
Virtual-Router
String:
virtual-router
-name
sublen21len26Specifies a
VR, other than
the VR
specified by
the
Virtual-Router
VSA, to which
the user has
access. You
can define
this VSA
multiple times
to define a set
of VRs to
which a user
has access.
Alt-CLI-Virtual-Router-
Name
VSA Configuration Examples
Consider a router on which five VRs have been configured. The VRs are called Boston,
Chicago, Detroit, Los Angeles, and San Francisco. The following examples illustrate
how to use the VSAs to control a user’s access to these VRs.
Example 1 In this example, you want the user to have access to all VRs and to log in to the
default VR. Accept the default setting or set the following VSA:
448 ■ Restricting User Access
JUNOSe 11.1.x System Basics Configuration Guide

Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X Specifications

General

Brand	Juniper
Model	SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X
Category	Software
Language	English