Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X User Manual

All the schema if-stats objects in Table 25 on page 216 apply to both layer 2 and layer
3 interfaces, except usdAcctngSpoofedPkts, which is specific to layer 3.
Defining all interface types before you map a collector to the if-stats schema ensures
that you display statistics for all configured interfaces in the first interval.
You can get more accurate rate statistics by using the time-offset parameter. To use
this parameter you must navigate to the if-stats subtreelist. The time-offset
parameter is included in each bulk statistics interface record and is the offset from
the master interval at which the record was collected.
IGMP Schema Objects
Table 26 on page 217 describes the IGMP objects that you can configure using the
bulkstats schema subtree igmp command.
Table 26: IGMP Schema Objects
DefinitionObject
Configure IGMP schema for all attributesall
Configure IGMP schema for destination addressdest-address
Configure IGMP schema for IGMP commandigmp-cmd
Configure IGMP schema for lower interfacelower-interface
Configure IGMP schema for multicast groupmulticast-group
Configure IGMP schema for router indexrouter-index
Configure IGMP schema for source addresssource-address
Configure igmp schema for time stamptime-stamp
Policy Schema Objects
Table 27 on page 217 describes the policy objects that you can configure using the
bulkstats schema subtree policy command.
Table 27: Policy Schema Objects
DefinitionObject
Configure policy schema for all statisticsall
Configure policy schema for green bytesgreen-bytes
Configure policy schema for green packetsgreen-packets
Configure policy schema for red bytesred-bytes
Collecting Bulk Statistics ■ 217
Chapter 4: Configuring SNMP

Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X Specifications

General

Brand	Juniper
Model	SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X
Category	Software
Language	English