Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X User Manual

Figure 25: Location of the Software Reset Button
NOTE: If you do not press the software reset button within the time limit, the system
will not erase the password, and you will need to repeat the process.
erase secrets
■ Use to delete all CLI passwords and secrets.
■ After you issue this command, press the software reset button (see Figure 25 on
page 423) within the time you specify for this command.
■ Allows you to set the number of seconds (1–60) for this procedure to be
accomplished.
■ Allows you to set a new password when you have forgotten your password.
■ Can be used with the service unattended-password-recoverycommand.
■ Example
host1>erase secrets 60
■ There is no no version.
■ See erase secrets.
service unattended-password-recovery
Setting and Erasing Passwords ■ 423
Chapter 7: Passwords and Security

Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X Specifications

General

Brand	Juniper
Model	SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X
Category	Software
Language	English