Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X User Manual

SNMP Event Manager Configuration Mode
In this mode, you can configure certain SNMP triggers for events, what occurs when
an event is triggered, resource limits for triggers, and some trap notification options.
From Global Configuration mode, type the snmp-server management-event
command and then press Enter.
host1(config)#snmp-server management-event
host1(config-mgmtevent)#?
default Set a command to its default(s)
do Run an exec mode command (alias command run)
event Specify what happens when an event is triggered
exit Exit from the current command mode
help Describe the interactive help system
log Configure logging settings
macro Run a CLI macro
no Negate a command or set its default(s)
resource Specify the resource limits
run Run an exec mode command (alias command do)
sleep Make the Command Interface pause for a specified duration
trigger Specify the conditions that lead to events
Statistics Profile Configuration Mode
In this mode, you can configure a statistics profile. You can then set the rate period
during which statistics are gathered, enable statistics gathering, and enable the
counting of drop and forwarding events.
From Global Configuration mode, type statistics-profile and the statisticsProfileName
that you want to create or configure, and press Enter.
host1(config)#statistics-profile statpro-1
host1(config-statistics-profile)#?
committed-drop-threshold Set threshold for logging a committed-drop event
conformed-drop-threshold Set threshold for logging a conformed-drop event
default Set a command to its default(s)
do Run an exec mode command (alias command run)
exceeded-drop-threshold Set threshold for logging an exceeded-drop event
exit Exit from the current command mode
forwarding-rate-threshold Set threshold for logging a forwarding-rate event
help Describe the interactive help system
log Configure logging settings
macro Run a CLI macro
no Negate a command or set its default(s)
rate-period Set the time period for calculating queue rates
run Run an exec mode command (alias command do)
sleep Make the Command Interface pause for a specified
duration
Subinterface Configuration Mode
In this mode, you can configure one or more virtual interfaces, called subinterfaces,
on a single physical interface. The system supports this feature with ATM and Frame
Relay.
Accessing Command Modes ■ 119
Chapter 2: Command-Line Interface

Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X Specifications

General

Brand	Juniper
Model	SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X
Category	Software
Language	English