Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X User Manual

The maximum number of interfaces for each type of interface and line module can
differ. Bulk statistics can collect these statistics when you configure the slots with
their respective interfaces to the corresponding maximum values. For information
about maximum values see JUNOSe Release Notes, Appendix A, System Maximums.
NOTE: Define all interface types before you map a collector to the if-stats schema
to ensure that you display statistics for all configured interfaces in the first interval.
The name of the bulk statistics file that is transferred to the host when there is a
collectorSequence attribute in the remote name is as follows:
fileName - z - mmddHHMM - s. sts
where:
■ fileName—Name of the file, which includes sysName, sysUpTime, depending on
the attributes specified
■ -z—Receiver index value
■ mmddHHMM—Timestamp when the receiver is created in month/day/hour/minute
format
■ -s—Actual sequence number
Interface Strings
Bulk statistics provides interface strings as described in Table 23 on page 196.
Table 23: Interface Strings
Common Description
Format-Mode Enabled
Common Description
Format-Mode DisabledType of Interface
IpIPIP interfaces
PppPPPPPP interfaces
Ds0Ds0DS0 interfaces
Ds1SERIALDS1 interfaces
Ds3SERIALDS3 interfaces
FrameRelayMajorFRFrame Relay Major interfaces
EthernetENETEthernet interfaces
SonetSONETSonet interfaces
SonetPathSONETSonet Path interfaces
AtmATMATM interfaces
196 ■ Collecting Bulk Statistics
JUNOSe 11.1.x System Basics Configuration Guide

Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X Specifications

General

Brand	Juniper
Model	SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X
Category	Software
Language	English