■ See the ERX Module Guide for modules supported on ERX7xx models, ERX14xx
models, and the ERX310 router.
■ See the E120 and E320 Module Guide for modules supported on the E120 router
and the E320 router.
References
For more information about SNMP, consult the following resources:
■ RFC 1157—A Simple Network Management Protocol (SNMP) (May 1990)
■ RFC 1901—Introduction to Community-based SNMPv2 (January 1996)
■ RFC 2790—Host Resources MIB (March 2000)
■ RFC 2864—The Inverted Stack Table Extension to the Interfaces Group MIB (June
2000)
■ RFC 2493—Textual Conventions for MIB Modules Using Performance History
Based on 15 Minute Intervals (January 1999)
■ RFC 3014—Notification Log MIB (November 2000)
■ RFC 3410—Introduction and Applicability Statements for Internet Standard
Management Framework (December 2002)
■ RFC 3411—An Architecture for Describing Simple Network Management Protocol
(SNMP) Management Frameworks (December 2002)
■ RFC 3412—Message Processing and Dispatching for the Simple Network
Management Protocol (SNMP) (December 2002)
■ RFC 3413—Simple Network Management Protocol (SNMP) Applications
(December 2002)
■ RFC 3414—User-based Security Model (USM) for version 3 of the Simple Network
Management Protocol (SNMPv3) (December 2002)
■ RFC 3415—View-based Access Control Model (VACM) for the Simple Network
Management Protocol (SNMP) (December 2002)
■ RFC 3416—Version 2 of the Protocol Operations for the Simple Network
Management Protocol (SNMP) (December 2002)
Before You Configure SNMP
Before you configure SNMP, make sure that at least one IP address is configured on
your router. See Accessing ERX Routers in the ERX Hardware Guide or Accessing E
Series Routers in the E120 and E320 Hardware Guide.
Also make sure that you have the necessary configuration information for:
■ Communities and their assigned privileges
■ IP addresses of SNMP clients and trap recipients
■ SNMPv3 users
References ■ 157
Chapter 4: Configuring SNMP
To Next Page
Loading...