Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X User Manual

redistribute Configure the redistribution of routing
information from another protocol
rib-out Configure rib-out storage for all BGP peers
run Run an exec mode command (alias command do)
sleep Make the Command Interface pause for a
specified duration
synchronization Enable synchronization with the IGP
table-map Specify a table map to map external entry
attributes into routing table
timers Configure the keep-alive interval and the hold-time
RSVP Configuration Mode
In this mode, you can create and configure MPLS Resource Reservation Protocol
(RSVP) parameters.
From Global Configuration mode, type mpls rsvp interface profile and the
profileName, and press Enter.
host1(config)#mpls rsvp interface profile sprint
host1(config-rsvp)#?
cleanup-timeout-factor Configure the timeout factor
default Set a command to its default(s)
do Run an exec mode command (alias command run)
exit Exit from the current command mode
help Describe the interactive help system
log Configure logging settings
macro Run a CLI macro
no Negate a command or set its default(s)
refresh-period Configure refresh period
run Run an exec mode command (alias command do)
sleep Make the Command Interface pause for a specified
duration
RTR Configuration Mode
In this mode, you can configure Response Time Reporter (RTR) parameters. The RTR
feature allows you to monitor your network’s performance and its resources by
measuring response times and the availability of your network devices.
From Global Configuration mode, type rtr and the mapNumber, and press Enter.
host1(config)#rtr 784078348
host1(config-rtr)#?
default Set a command to its default(s)
do Run an exec mode command (alias command run)
exit Exit from the current command mode
frequency Specify the frequency interval
help Describe the interactive help system
hops-of-statistics-kept Specify the hops capture
log Configure logging settings
macro Run a CLI macro
max-response-failure Specify the maximum number of consecutive failures
no Negate a command or set its default(s)
operations-per-hop Specify a number of operations per hop
owner Specify the owner of entry
request-data-size Specify the request payload size
Accessing Command Modes ■ 117
Chapter 2: Command-Line Interface

Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X Specifications

General

Brand	Juniper
Model	SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X
Category	Software
Language	English