Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X

Table 29 on page 224 shows the mapping between the bulkstats output and the CLI
and MIBs for policy schema.
Table 29: Mapping Bulkstats Output to MIB Flies and CLI Configurations for Policy Schema
DescriptionCLI ConfigurationMIB Object NameMIB File
Bulkstats Output
Column Name
Configure IfStats schema
for all stats
all
A textual string containing
information about the
interface. This string should
include the name of the
manufacturer, the product
name and the version of
the interface
hardware/software
–ifDescrRFC1213ifDescr
The type of interface.
Additional values for ifType
are assigned by the Internet
Assigned Numbers
Authority (IANA), through
updating the syntax of the
IANAifType textual
convention
-ifTypeRFC1213ifType
Identifies the type of this
interface
-juniIfTypejuniIfusdIfType
A unique value, greater
than zero, for each
interface. It is
recommended that values
are assigned contiguously
starting from 1. The value
for each interface sub-layer
must remain constant at
least from one
re-initialization of the
entity's network
management system to the
next re- initialization
-ifIndexRFC1213ifIndex
Report State:
IfStatsReportInterim =
Interim Accounting data
---IfStatsReportState
224 ■ Collecting Bulk Statistics
JUNOSe 11.1.x System Basics Configuration Guide