Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X User Manual

Table 29: Mapping Bulkstats Output to MIB Flies and CLI Configurations for Policy Schema (continued)
DescriptionCLI ConfigurationMIB Object NameMIB File
Bulkstats Output
Column Name
The total number of octets
received on the interface,
including framing
characters. This object is a
64-bit version of ifInOctets
Discontinuities in the value
of this counter can occur at
re-initialization of the
management system, and
at other times as indicated
by the value of
ifCounterDiscontinuityTime
in-octetsifHCInOctetsRFC2863ifHCInOctets
The number of packets,
delivered by this sub-layer
to a higher (sub-)layer,
which were not addressed
to a multicast or broadcast
address at this sub-layer.
This object is a 64-bit
version of ifInUcastPkts
Discontinuities in the value
of this counter can occur at
re-initialization of the
management system, and
at other times as indicated
by the value of
ifCounterDiscontinuityTime
in-ucast-pktsifHCInUcastPktsRFC2863ifHCInUcastPkts
The number of inbound
packets which were chosen
to be discarded even
though no errors had been
detected to prevent their
being deliverable to a
higher-layer protocol. One
possible reason for
discarding such a packet
could be to free up buffer
space
Discontinuities in the value
of this counter can occur at
re-initialization of the
management system, and
at other times as indicated
by the value of
ifCounterDiscontinuityTime
in-discardsifInDiscardsRFC1213ifInDiscards
Collecting Bulk Statistics ■ 225
Chapter 4: Configuring SNMP

Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X Specifications

General

Brand	Juniper
Model	SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X
Category	Software
Language	English