Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X User Manual

From Rate Limit Profile Configuration mode, type the color-mark-profile command
and specify a profileName, and then press Enter.
host1(config-rate-limit-profile)# mpls color-mark-profile myprofile
host1(config-color-mark-profile)#?
default Set a command to its default(s)
do Run an exec mode command (alias command run)
exit Exit from the current command mode
green-mark Apply TOS mark to IP packets classified Green by the rate limit
hierarchy
help Describe the interactive help system
log Configure logging settings
macro Run a CLI macro
mask-value Mask for all TOS values applied by the color-mark profile
no Negate a command or set its default(s)
red-mark Apply TOS mark to IP packets classified Red by the rate limit
hierarchy
run Run an exec mode command (alias command do)
sleep Make the Command Interface pause for a specified duration
yellow-mark Apply TOS mark to IP packets classified Yellow by the rate limit
hierarchy
Control Plane Configuration Mode
In this mode, you can configure policing for a specific protocol.
From Global Configuration mode, type the control-plane command and press Enter.
host1(config)#control-plane
host1(config-control-plane)#?
default Set a command to its default(s)
do Run an exec mode command (alias command run)
exit Exit from the current command mode
help Describe the interactive help system
log Configure logging settings
macro Run a CLI macro
no Negate a command or set its default(s)
policer Configure policing
run Run an exec mode command (alias command do)
sleep Make the Command Interface pause for a specified duration
Controller Configuration Mode
You can configure physical interfaces such as a T3 in Controller Configuration mode.
From Global Configuration mode, type the appropriate controller command and its
attributes, and then press Enter.
host1(config)#controller t3 9/1
host1(config-controll)#
host1(config)#controller ?
e1 Configure a channelized E1 controller
e3 Configure a E3 controller
sonet Configure a Sonet controller
t1 Configure a channelized T1 controller
t3 Configure a T3 controller
92 ■ Accessing Command Modes
JUNOSe 11.1.x System Basics Configuration Guide

Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X Specifications

General

Brand	Juniper
Model	SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X
Category	Software
Language	English